PRECISION SUPPLY -- SUPER SEAL  -- 8030-00N059907
<pre>=====================  Product Identification  =====================

Product ID:SUPER SEAL
MSDS Date:06/28/1993
FSC:8030
NIIN:00N059907
=== Responsible Party ===
Company Name:PRECISION SUPPLY
Address:4450 CALIFORNIA AVE SUITE 137
City:BAKERFIELD
State:CA
ZIP:93309
Country:US
Info Phone Num:805-871-8492
Emergency Phone Num:800-255-3924
CAGE:0G6E4
=== Contractor Identification ===
Company Name:PRECISION SUPPLY
Address:4450 CALIFORNIA AVE SUITE 137
Box:City:BAKERFIELD
State:CA
ZIP:93309
Country:US
Phone:805-871-8492
CAGE:0G6E4

=============  Composition/Information on Ingredients  =============

Ingred Name:SILANE, METHYLTRIACETOXY-
CAS:4253-34-3
RTECS #:VV4500000
Fraction by Wt: 1-10%
OSHA PEL:N/K 
ACGIH TLV:N/K 

Ingred Name:ETHYLTRIACETOXYSILANE
CAS:17689-77-9
Fraction by Wt: 1-10%
OSHA PEL:N/K 
ACGIH TLV:N/K 

Ingred Name:SILICA GEL; (SILICA)
CAS:112945-52-5
RTECS #:VV7310000
Fraction by Wt: 1-10%
OSHA PEL:6 MG/M3
ACGIH TLV:10 MG/M3

Ingred Name:POLYMER
CAS:70131-67-8
Fraction by Wt: 80-90%
OSHA PEL:N/K 
ACGIH TLV:N/K 

Ingred Name:HYDROCARBON PROPELLANTS; (OUTER COMPARTMENT CONTAINS A
    FLAMM HYDROCARBON PROPELLANT (PROPANE/ISOBUTANE/N-BUTANE BLEND))
OSHA PEL:N/K 
ACGIH TLV:N/K 

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:ACUTE/CHRONIC: NO INJURY FROM SILICA
    DUST SHOULD OCCUR DURING REASONABLE USE. IF USE CREATES RESP
    PARTICLES, SOME RESP SYS INJURY MAY OCCUR. THIS PROD, AS W/ANY
    CHEM, MAY ENHANCE ALLERGIC CNDTNS IN CE RTAIN PEOPLE. NO KNOWN
    CHRONIC HLTH EFTS, BUT UNEC EXPOS TO ANY CHEM SHOULD BE AVOIDED.
    CURED SEALENT IS NON-HAZARDOUS.
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:SWALLOWING LARGE AMOUNTS MAY CAUSE DIGESTIVE
    DISCOMFORT. VAPOR OVEREXPOSURE MAY IRRITATE NOSE, THROAT AND EYES
    SERIOUSLY WITH MODERATE CORNEAL INJURY AND CONSIDERABLE REDNESS
    LASTING A WEEK OR MORE.
Medical Cond Aggravated by Exposure:NONE KNOWN.

=======================  First Aid Measures  =======================

First Aid:EYES/SKIN: FLUSH WITH WATER FOR AT LEAST 15 MINUTES.
    INHALATION: REMOVE TO FRESH AIR. INGESTION: CALL MD IMMEDIATELY .

=====================  Fire Fighting Measures  =====================

Flash Point Method:TCC
Flash Point:212F,100C
Extinguishing Media:USE WATER FOG, DRY CHEMICAL OR CARBON DIOXIDE.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
    PROTECTIVE EQUIPMENT . CANS MAY RUPTURE WHEN HEATED.
Unusual Fire/Explosion Hazard:HEATED CANS MAY BURST. SIO*2, CO*2.

==================  Accidental Release Measures  ==================

Spill Release Procedures:REMOVE PRODUCT AND CONTAIN FOR SALVAGE
    DISPOSAL.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:KEEP AWAY FROM HEAT, SPARKS, OR OPEN
    FLAME. STORE AT TEMPERATURES BELOW 120F.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:USE NIOSH/MSHA APPROVED SCBA IF ABOVE TLV LIMIT
    EXCEEDING. WHEN SPRAYING MORE THAN ONE HALF CAN CONTINUOUSLY OR
    MORE THAN ONE CAN CONSECUTIVELY, USE NIOSH/MSHA APPROVED
    RESPIRATOR.
Ventilation:LOCAL EXHAUST.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGS .
Other Protective Equipment:WEAR LONG SLEEVES AND LONG PANTS.
Work Hygienic Practices:DO NOT SMOKE WHILE USING. WASH HANDS AFTER USE.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.

==================  Physical/Chemical Properties  ==================

Vapor Pres:66 PSIG
Vapor Density:HVR/AIR
Spec Gravity:1.04 (H*2O=1)
Evaporation Rate &amp; Reference:<1 (BUTYL ACETATE=1)
Solubility in Water:NIL
Appearance and Odor:CLEAR PASTE WITH SLIGHT MEDICINAL ODOR

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS. WATER CAUSES CURING.
Stability Condition to Avoid:HIGH TEMPERATURES.
Hazardous Decomposition Products:ACETIC ACID FUMES, SIO*2, CO*2.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE W/LOCAL, STATE &
    FEDERAL REGULATIONS .

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.